Product Data Sheet
MSDS Code G.P.
       

Product

Synthepol P925MF Marine Putty
Type

A Flexible MEKP Cured, Unwaxed Polyester Putty For Coving and Bonding of GRP Components.
Applications
*Coving prior to glassing sharp corners *Bonding stringers prior to glassing
*Bonding sanded GRP parts together *General filling of GRP components
Application Method
*Trowel or putty knife  
Features
*Extreme flexible and tough when cured. *Promoted
*Excellent edhesion to well sanded GRP *Unwaxed
*Lighter weight than most putties  
*MEKP cured  
*Non slump even in relatively thick applications  
Typical Properties
*Appearance in can White
*Specific gravity 0.8
*Gel time at 25º C with 2% MEKP 18-24 minutes
*Flammability High
*Flashpoint 31º C
*Shelf stability 6 months minimum
Directions
 Synthepol Marine Putty should be catalysed with 1.5 - 2% MEKP and mixed thoroughly before application to the substrates. When used to bond components together, we recommend that tests are carried out to ensure that this product is suitable for the purpose for which it is to be used for.
Storage
 All Synthepol polyester products should be stored in closed containers away from
any source of ignition and out of direct sunlight at temperatures below 25º C.

All information and products are supplied in good faith, without warranty expressed or implied that they are suitable for any particular purpose, and any statements concerning the possible uses of our products are not intended as recommendations to use our products in the infringement of any patent.We cannot anticipate or control the many different conditions under which our products may be used, and therefore recommend that our clients test and evaluate the products and information to determine theiir suitability for the intended purpose.
Back to resin page
 
Synthepol
A Division Of Chemical Specialties Ltd
116 Princes St. Onehunga. P.O.Box, 29109 Greenwoods Cnr, Auckland, New Zealand.
Phone 0064 9 636 8618. Fax 0064 9 636 8618. E Mail synthepol@chemspec.co.nz