Product Data Sheet
MSDS Code G.P.
       

Product

Synthepol P712
Type

Isophthalic Polyester Flowcoats.
Applications
*To improve the appearance of the back of fibreglass laminates, by sealing the surface to give a low- gloss, pigmented, fibre- free finish.
Application Method
*Brush *Roller *Spray
Features
*Sag resistant *Semi-gloss finish
*Flows well *Tack free surface
*Good covering power  
*Available in White,Light Grey, and some other colours
 
*Excellent adhesion  
Typical Properties
*Viscosity at 25º C (Brookfield RVT Sp 5/100 rpm) 2700-3200 cps
*Specific gravity 1.2
*Gel time at 25º C with 1% MEKP 10-15 minutes
*Flammability High
*Flashpoint 31º C
*Storage stability 6 months minimum
*Barcol 934.1 hardness 35- 40
Directions
 Synthepol Top Flow Flowcoat should be catalysed with 1-2% MEKP and mixed
thoroughly prior to application to the laminate. The ratio of catalyst can be varied to
adjust the gel time and cure. For best results workshop temperatures should be
maintained above 15º C in order to ensure that a satisfactory cure is obtained.
Storage
 All Synthepol polyester products should be stored in closed containers away from
any source of ignition and out of direct sunlight at temperatures below 25º C.

All information and products are supplied in good faith, without warranty expressed or implied that they are suitable for any particular purpose, and any statements concerning the possible uses of our products are not intended as recommendations to use our products in the infringement of any patent.We cannot anticipate or control the many different conditions under which our products may be used, and therefore recommend that our clients test and evaluate the products and information to determine theiir suitability for the intended purpose.
Back to resin page
 
Synthepol
A Division Of Chemical Specialties Ltd
116 Princes St. Onehunga. P.O.Box, 29109 Greenwoods Cnr, Auckland, New Zealand.
Phone 0064 9 636 8618. Fax 0064 9 636 8618. E Mail synthepol@chemspec.co.nz